Hi! On Tue, Jan 05, 2010 at 10:32:39PM -0800, Shawn Jefferson wrote: > I have some code that used to compile and run fine, but now is returning > the wrong result. I’ve attached the generated assembly listing for the > code. I’ve also included the previous calculation for completeness. I've fixed the problem in the head branch. It is also in 2.13.1, but before applying it there, I would like to wait some time to see if the fix has any bad consequences. Is it possible that you try your code with the new snapshot built this night (I'm not at home in the moment, so it's somewhat difficult for me to trigger a new build immediately). Thanks again for the report! Regards Uz -- Ullrich von Bassewitz uz@musoftware.de ---------------------------------------------------------------------- To unsubscribe from the list send mail to majordomo@musoftware.de with the string "unsubscribe cc65" in the body(!) of the mail.Received on Wed Jan 20 20:52:02 2010
This archive was generated by hypermail 2.1.8 : 2010-01-20 20:52:06 CET